jump to navigation

BMW X6M suspension secrets July 25, 2009

Posted by richard in : Technology , add a comment

STANDARD BMW X6 models, in corners, work harder, earlier, for agility.

And that, explains Head of M Development Albert Biermann, is down to how the clever torque vectoring rear axle is programmed: power is shuffled round quite considerably, to give a rear-steer effect and kick the back end into corners.

bmw_x6m_6The X6M uses this same technology – but is more linear. ‘It is not as agile, so we don’t work the rear end as much early on.

‘However, once you’re within the corner, we engage it far more – here, the split happens much earlier than in the standard X6.’

Why? ‘So the driver can get on the throttle earlier.’ And feel the ‘rear drive’ balance M reckons is a characteristic of its cars.

It’s not only here where the ‘M-gineers’ (arf) have been busy. ‘Dampers and springs are stiffer – and there are bespoke EDC settings. The ABS and Dynamic Drive are specially adjusted – the stiffness of the roll bar goes hand-in-hand with the dampers.’

bmw_x6m_2There are stiffer upper wishbone hearings, and stiffer rubber in the rear axle carrier. ‘This gives better off-centre feel and more precision.’ The engine mounts are stiffer, too.

‘The upper shock mounts are also completely different.’ This solution, says Biermann, was very expensive, and could be easily overlooked. It shouldn’t be.

In the standard X6, there are three components, all settled together in the upper mounting. This sees the helper spring and damper share a common rubber bearing.

It’s a compromise. The helper spring is offsetting the rubber bearing over a spring, for example.

bmw_x6m_5So, with the X6M, we’ve separated the bearing and piston rod from the helper spring. This means the two bearings fit better together; and one is dedicated to the damper, the other to the helper spring.

Advantages? Considerable, especially over challenging roads. It’s particularly good for comfort – it’s at least as good as the regular X6…

BMW Z4 has 3 Series Convertible to thank

What Porsche gives to BMW M

BMW MX5… MX6…

VN:F [1.8.5_1061]
Rating: 0.0/10 (0 votes cast)
VN:F [1.8.5_1061]
Rating: 0 (from 0 votes)

How do you make a BMW X6M? July 20, 2009

Posted by richard in : Technology , 1 comment so far

BMW X6M. Or, but for Mazda, the MX6. What in Lord’s name is it all about, ask hardcore M fans worldwide.

Well,  it was certainly a challenge, admits M Head of Product Management, Carsten Pries.

bmw_x6m_1‘M cars,’ he revealed, when asked about the process of the X6M’s creation, ‘must display the core values of the brand.’

Which are?

According to our man Pries, M cars must be best in:

•    Acceleration
•    Lateral dynamics
•    Efficiency
•    Steering behaviour
•    Braking distance

He admits they weren’t sure the X6 could be made suitably ‘M’ at first. The department eventually figured it could – but it wouldn’t be simply a matter of making a big M3.

‘Customers in this segment are different to M3 buyers. We thus had to define in the early stages exactly what these new needs were.’

bmw_x6m_2An SAV, he says, is ‘completely different’, particularly in terms of size and weight. It is therefore vital to develop a good sense of the key requirements.

Which are not the same as an M3, whose buyers are ‘deep into technology – they go into dealers and give them a hard time with their in-depth knowledge! They know so much…’

So what about these M SAV (or, as the rest of the world prefers, ‘SUV’) buyers? ‘They’re performance orientated, but not that into the last technical detail. They want high performance, and a differentiated character in terms of suspension, chassis, steering and design.

‘It needs to be dynamic, easy to control, have a clear emphasis on rear-wheel drive.’ M-lite, if you like. M with bling, you could also say.

See, it is vital the model is highly exclusive – a particular requirement for this segment. ‘It must stand out, be instantly recognisable as something different to an xDrive50i. It should be seen as being the latest, the most powerful. It’s also not a car for people who just like to pretend. Form must follow function. ‘

bmw_x6m_3What Pries means here is that it should not be merely chavv’d up. A no to show without go.

There was another consideration, too. ‘It was vital we didn’t compromise its off-road ability. People want to take these to the Alps – if we restrict this in any way, it will not be as successful as we wish.’

No wonder it took them two and a half years to develop.

Along the way, he ditched potential grumble-areas. BMW M drivers, it seems, don’t like Active Steering. Their power steering systems have to be consistent. That’s why M spent big developing a bespoke Servotronic steering system for its most expensive X SUVs.

Servotronic means variable weight – it’s light at low speeds, weightier at higher speeds – but the steering ratio is consistent.

bmw_x6m_4‘We intentionally didn’t use Active Steering – the steering angle must be consistent whatever the road speed,’ says Pries. ‘This is appreciated by our sports car drivers…’

There it is again. Sports car drivers. BMW’s thought long and hard about this one, about whether an SUV can actually also be an M. It reckons so.

Me? The jury’s out…

BMW Z4 has 3 Series Convertible to thank

What Porsche gives to BMW M

BMW tells me why its instruments are lit in orange

VN:F [1.8.5_1061]
Rating: 0.0/10 (0 votes cast)
VN:F [1.8.5_1061]
Rating: 0 (from 0 votes)

BMW LCI not ASAP for M July 18, 2009

Posted by richard in : Minutiae of cars , 1 comment so far

BMW facelifted the 3 Series last year. Odd, how M hasn’t followed with the M3. Why’s that?

Well, it’s because M has such independence from BMW AG.

BMW LCI not ASAP for MIt’s able, says Head of Product Management Carsten Pries, to make deliberate decisions separately from mainstream BMs

‘We launched the M3 in March 2008,’ says Pries. ‘In September, AG launched the LCI (life cycle impulse) 3 Series. We didn’t follow, keeping instead the same existing front end.

BMW LCI not ASAP for M 2Why? ‘Because we didn’t think it was necessary.’

The M3, says Pries, is suitably differentiated from the 3 Series not to need the additional expense of an (admittedly subtle) LCI so soon into its like. ‘We carried over the revised design tail lights, that’s all.’

This independence, he adds, comes through M being so well integrated into BMW AG. It can make unilateral decisions 12, even 24 months ahead, as it did in this case.

‘It’s exciting to do LCIs – as with the M6 Competition – but if it’s not necessary, we won’t automatically do it.’

Purity and purpose, rather than marketing for marketing’s sake. That’s M. Now, the X6M…

BMW Z4 has 3 Series Convertible to thank

What Porsche gives to BMW M

BMW tells me why its instruments are lit in orange

VN:F [1.8.5_1061]
Rating: 0.0/10 (0 votes cast)
VN:F [1.8.5_1061]
Rating: 0 (from 0 votes)

BMW M X5… M X6… April 4, 2009

Posted by richard in : Uncategorized , 2comments

BMW’s M range is heading off road.

Canny resource bmwblog.com has snared uncovered images of two whizz new M models – the X5M and X6M.

bmwblogYes, you read that right. The X6 is being M’d up. Meaning it now has the missilepower to match its unmistakeable looks.

Beneath the bonnets of both is a 4.4-litre V8, that M’s rocked up to 555, yes, 555bhp. 555bhp. Jeez. And 500lb/ft of torque, delivered in a turbo-thrusted wave from 1500 to 5650rpm.

How could they not be logic-defyingly fast? 0-60mph in 4.5 seconds, for the record. That’s Porsche fast. Despite both being hulking great off-roaders.

How bmwblog got the info, I do not know. Fair play, though. It’s helped whizz up the excitement a notch further, of two off-message but still on-key off-roaders.

Note the arrangement of the letters, mind. Seems Mazda’s MX-5 copyright extends to the late, not-lamented MX-6, too.

mazda_mx_6_2

BMW X5 – reviewing the 2007 launch

BMW Z4 development background

BMW Z4 chassis secrets

VN:F [1.8.5_1061]
Rating: 0.0/10 (0 votes cast)
VN:F [1.8.5_1061]
Rating: 0 (from 0 votes)